Product intro and specs
The Asvape MICRO Pod is an adjustable 30-watt AIO in a Billet Box-style design. The Billet Box-style AIOs are turning out to be the “thing” for 2019, rivaling if not surpassing the Orion-style AIOs.
The Asvape MICRO Pod is a really good-looking kit with stunning resin panels and a matchy-matchy drip tip. The kit comes with two mesh coils: a 0.5-ohm DL and 1.0-ohm MTL coil. It has both adjustable wattage and airflow, and it’s powered by an 1100 mAh battery with a USB-C charge port. On paper, and especially in the hand, the device looks like it has everything it needs to be one of the best kits this year. But does it vape as good as it looks?
Myvpro sent me this kit for the purpose of this review.
Price: $41.95 (at Myvpro)
Colors: black/white resin, green/purple resin, orange/blue resin, yellow/purple resin, red/blue resin
- Dimensions – 70mm by 43mm by 18mm
- Integrated 1100mAh Rechargeable Battery
- Wattage Output Range: 5-30W
- Intelligent Resistance ID
- Zinc-Alloy & Resin Chassis Construction
- Single Button Operation
- Two Interior Adjustment Buttons
- Interior LED Display Screen
- Interior Pod Storage & Connection
- 2mL Refillable Pod – Replaceable Coil
- Side Fill System – Silicone Stoppered
- Asvape MICRO Coil Series
- 0.5ohm Mesh DTL Coil – rated for 70/30 VG/PG ratio
- 1.0ohm Mesh MTL Coil – rated for 50/50 VG/PG ratio
- Push Coil Pod Installation
- Threaded Coil Airflow Installation
- Dual Slotted Adjustable Coil Airflow Ring
- Low Battery Protection
- Too Hot Protection
- Short-Circuit Protection
- Low Resistance Protection
- 10s Overtime Protection
- Low Battery Protection
- Proprietary Resin Drip Tip
- USB Type-C Port
- MICRO Pod System
- 0.5ohm Mesh DTL Coil
- 1.0ohm Mesh MTL Coil
- Extra Plug
- 2x O-Rings
- User Manual
- Warranty Card
- USB Type-C Cable
Build quality and design
The Asvape Micro Pod isn’t really micro and technically it’s not a pod; it’s an AIO. The Micro Pod measures 18 mm x 43 mm x 70 mm (not including the tip); it weighs about 83 g. It’s a compact kit with an easy access removable panel that reveals the cartridge and airflow control, as well as the adjustable wattage buttons and a small but bright LED screen that shows the battery level and power setting. The button is on the opposite side of the removable panel and it’s embossed with the Asvape logo. Mine is clicky and has no rattle or wiggle room.
The resin panel is held in by relatively strong magnets and slides on track halfway open for easy access. You can easily remove the entire panel just by pulling it off after sliding it to the side, but if you only need access to the cartridge or adjustable wattage, the track will prevent the panel from sliding beyond the halfway point. It’s a simple design but it works well. Also, there’s a little side-play when you push a little with your thumb. And if you drop the Micro Pod, the panel will come off and the removable 510 drip tip can also pop off. The tip isn’t seated as firmly as I would like. I can easily pull it out with my lips. It’s a gorgeous tip, but the O-rings should be beefier. Also, the drip tip opening is a bit wide for a legit MTL.
When holding the device, you have to be careful of palming it like a box mod because you can cover up intake on the outside. That shouldn’t be such an issue because the button placement pretty much forces you into holding it with your fingertips and thumb.
As far as aesthetics, this kit looks amazing! Even the packaging is nice. What I thought was just the reviewer packaging is actually the retail packaging. It comes in a corrugated flip-top box that matches the color of the mod. The device and panel are displayed nicely inside when you open it. As for the device, the chassis is made of a vibrant but matte colored zinc-alloy that matches with one of the colors of the drip tip and resin panels. The resin panels are really well-done. A lot of resin on the market looks haphazard, but the MICRO resin is very attractive in both the swirls and the color-combos. It’s clearly designed by someone that knows their way around a color wheel. Secondary colors like green and purple looks great together, along with complimentary colors like blue and orange, or yellow and purple. My favorite color combination on this kit (and in general) is purple and green. It’s the Joker “look.” Arthur would approve.
Coils and cartridges
The 2 mL cartridges are dark tinted and there’s no juice window. To see your juice level, it’s best to remove the cartridge altogether.
The cartridge slides into the device to make a connection. They only slide in one way, so you have to make sure the rounded corner meets up with the right side. The pod isn’t held in as snug as the Rincoe TIX, so don’t misplace the panel like I did with the TIX.
The refill is a little rubber plug near the top of the pod on the side. It’s easy to pull off and it’s anchored to once side. The refill port is about 4.5 mm, so every dropper will fit.
Coils heads and airflow controller
The heads screw directly into the airflow controller before getting screwed into the bottom of the cartridge. The airflow controller stops on the turn but too far away from the internal airflow slot. It can be a little tricky to adjust when the cartridge is inside the device. I find it easiest to pull out the cartridge and adjust it.
The Micro comes with two mesh coil heads:
- 0.5-ohm DL head; rated for 70 VG
- 1.0-ohm MTL head; rated for 50 VG
Both heads have the same airflow which interferes with the 1.0-ohm achieving an optimal MTL. It can be done when closing off the airflow controller, but it doesn’t quite feel right as a strict MTL. Another issue with the heads is that they have a bit too much cotton. Because of that, I’ve had some issues wicking 70 VG, even with the 0.5-ohm coil head.
I think both heads work best with 50/50 juice or no more than 60 VG, whether high nic or low nic. You can use 70 VG with the 0.5-ohm heads if you take it easy on them, but you may run into dry hits when chain vaping. I’ve been using medium strength regular nic (12 mg/mL) Five Pawns for both coils.
Lastly, the 2 mL capacity doesn’t fare too well with the coil heads. You will need to refill often.
The Asvape Micro Pod goes up to 30 watts. The adjustment buttons work fine, but they scroll slowly and only in 0.1-increments. I really don’t see the need for 0.1-increments for a device like this. I’d prefer it to be adjusted in 1-watt increments. And although it goes up to 30 watts, I don’t know what coil Asvape expects you to use at with that power. Beyond 20 watts on the 0.5-ohm coil, it gets too toasty. Trying that coil at 30 watts is simply no bueno!
Aside from the wicking issues I mentioned that mostly occurred with 70 VG, the Asvape Micro Pod performs exceeded my expectations when things are going smoothly. The flavor is above average for an AIO and especially a pod kit. I’v had no issues with spitting, popping, or gurgling, even with using 50/50 juice most of the time.
With the 1.0-ohm coil, I can get a good MTL, but I wish the drip tip and coil head diameter had a narrower ID. Luckily you can replace the tip—though nothing will look as good on this as the included tip. The tip doesn’t really affect the performance that much, but it does prevent it from being a great MTL vape.
However, with the 0.5-ohm head and the 1.0-ohm head, you can get a really good loose MTL or a as much as a restricted lung hit with the 0.5-ohm. That’s why I think it’s best to use 12 mg regular nic. It’s the perfect middle ground for this device with either coil.
Based on my experience:
- 0.5-ohm is best with max 60 VG; up to 20 watts
- 1.0-ohm is best with max 50 VG; up to 12 watts
The lifespan of the coils has been average at best. With some of the coils I’ve used, they didn’t make it past much more than one refill before tasting off, but that was when I was trying to use 70 VG. When using 50/50, I’ve been able to get a couple refills without too much of a drop off. Hopefully a couple refills are not the best they can do. If I have something else to report I’ll update this review.
The Asvape Micro Pod has an 1100 mAh battery that seems to last a long time. I have several of these in rotation and haven’t drained a battery yet, so I can’t say how long a charge takes. But I have checked, and it does not have pass-thru charging.
One thing the device has that I’m a big fan of is USB-C charging. It’s just a more convenient way to charge. I think it’s time for all vape devices with internal batteries to move to USB-C charging.
Pros / Cons
- Nice display box
- Gorgeous aesthetics
- Real resin
- Sliding resin panel works well
- USB-C charge cord
- Good flavor
- Airflow control
- MTL up to a restricted lung hit
- Adjustable wattage
- Long-lasting battery
- Comes with two coils
- Wicking issues with 70 VG
- Loose-fitting drip tip
- Slow wattage adjustment without round-robin
- Cartridge could fit a little more snug
I think Asvape did well with this device, though the coils are still a bit iffy to me. I sure do like it better than their Touch pod though. The main thing that bugs me a bit is that the 0.5-ohm coil should be able to handle 70 VG better. But other than that, I don’t have any major reservations recommending the Asvape Micro Pod. But make sure you’re aware of the cons of the device. It’s a good device that looks great, but there’s still room for improvement.
I’m the chief editor here at Vaping360 and I reside in southeast Michigan. I’ve been vaping since my first ecig purchase in 2010. For more reasons than I can list, vaping has been a lifesaver for me. Now, my goal is to help other smokers make the switch.
Let’s block ads! (Why?)